To Next PageTo Next PageWhat to do if my Argox Barcode Reader printer times out?
If the Argox Barcode Reader printer times out, ensure the communication cable (serial) is securely connected to both the PC's serial port and the printer's connector. Also, verify that the printer power is turned on.
Why are the Power and Ready LEDs blinking at the same tempo on my Argox Barcode Reader?
If the Power and Ready LEDs on your Argox Barcode Reader are blinking at the same tempo, it could be due to several reasons: * A miss-detected gap: Check the label path and label sensor. * The label stock is out: Supply the label roll. * The label stock is not installed: Install the label roll. * A label jam: Recover the jam.
What does it mean when the Power and Ready LEDs blink alternately on my Argox Barcode Reader?
If the Power and Ready LEDs on your Argox Barcode Reader are blinking alternately, it could be due to: * Ribbon out: Supply the ribbon roll. * Ribbon jam: Recover the jam. * Ribbon sensor error: Replace ribbon sensor.
Why is the Power LED blinking on my Argox Barcode Reader?
If the Power LED on your Argox Barcode Reader is blinking, this could indicate a few issues: * Serial IO error: Check the baud rate. * Memory full: Add an extension RAM (flash memory card). * Cutter failed or jam at cutter: Check the cutter and recover the jam. * Hardware error: Call for service.
Why is the Ready LED blinking on my Argox Barcode Reader?
If the Ready LED is blinking on your Argox Barcode Reader, it means the print head is too hot. Printing will stop until the print head cools to an acceptable printing temperature, at which point the printer will automatically resume operation.
How to fix vertical streaks in the printout of my Argox Barcode Reader?
If you observe vertical streaks in the printout from your Argox Barcode Reader, it may be due to a dirty or faulty print head. Clean the print head, and if the problem persists, replace it.
What to do if my Argox Barcode Reader has poor printout quality?
If you are experiencing poor printout quality with your Argox Barcode Reader, consider the following: * The ribbon may not be qualified. * The media may not be qualified. * Adjust the Darkness (heat temperature). * Slow down the print speed.
General| Print Technology | Thermal Transfer / Direct Thermal |
|---|---|
| Print Resolution | 203 dpi |
| Media Width | 25.4 mm - 114 mm |
| Memory | 8 MB Flash |
| Connectivity | USB, Serial |
| Print Width | 104 mm (4.09") |
| Processor | 32-bit RISC |
| Label Width | 25.4 mm - 114 mm |
| Power Supply | 100-240V AC, 50/60 Hz |
| Media Thickness | 0.06 mm (0.003") ~ 0.25 mm (0.01") |
| Label Thickness | 0.06 mm (0.003") ~ 0.25 mm (0.01") |
Instructions for checking the printer and its packaging for damage.
List of items included in the printer package.
Identification and description of the printer's components.
Explanation of the printer's buttons and status lights.
Detailed steps for installing a ribbon roll.
Instructions for loading media in standard operation mode.
Instructions for loading media for peel-off functionality.
Instructions for loading media when using the cutter function.
Steps to calibrate the printer and print a report.
Instructions to restore the printer to its original settings.
Details on the specifications for USB connectivity.
Details on the RS-232 serial interface.
Steps for cleaning key printer components.
Overview of the printer's technical characteristics.
