Argus E25 MOD II - Storage and Transport Guidelines; Actuator Storage Conditions

Argus E25 MOD II - Operating Instructions
14
Storing and transporting the
unit
ATTENTION!
Incorrect
storage or transport can
damage
the unit.

Close all openings with the
covers supplied or similar co-
vers.

Make sure the unit is dry and
protected from corrosive at-
mospheres where it is stored.

Contact the manufacturer for
advice if you need to store or
transport the unit under other
conditions.
Storing the Actuator
Store the unit only under the following
conditions:
 Do not store it for more than 24
months.
 Close all connection openings with the
covers supplied or similar covers.
 The connection surfaces and sealing
surfaces must be protected against
mechanical damage.
 The unit and all its components must
be protected from blows and shocks.
 Secure the unit to prevent it falling or
tipping.
 The unit shall only be installed indoors
under the following environmental
conditions:
 Relative humidity below 50%, non-
condensing
 The room air must be clean and not
contain salt or other corrosive sub-
stance
 Temperature 5 - 40 °C.
When storing, make sure these condi-
tions apply at all times.
Contact the manufacturer for advice if
you need to store the unit for longer or
under other conditions.