Argus E25 MOD II User Manual

Argus E25 MOD II - Operating Instructions
15
Transporting the unit
For transport maintain the same con-
ditions as specified for storage.
Before transport, fit plugs to the con-
nections.
If
the plugs originally supplied are
not
available, use comparable
plugs
and covers to close the
connections.
DANGER
Danger
of crushing injury if the
unit
or its components fall or tip.

During any work on the unit,
wear suitable protective cloth-
ing.

Whenever lifting or moving the
unit or i
ts components to work
on them, use suitable lifting
gear.

Make sure the unit cannot tip
over.

When lifting the unit, sling it
only on its body.

Make sure that there are nev-
er persons under suspended
loads.
Protective clothing must comprise at
least the following items:
 Hard hat to EN 39
7
 Safety shoes to EN ISO 20345
 Robust l
eather gloves to EN 388
For more information about suitable safe-
ty clothing and protective equipment, see
the safety data sheet for the substances
being handled.
The lifting gear must have adequate load
capacity for the unit including the valve
on which it is mounted.
For more information about the weight of
the actuator, please see the documenta-
tion supplied with it. In the event of it
being supplied with a ball valve or ball
valve combination, you will find infor-
mation about the weight of the compo-
nents in the manufacturer’s documenta-
tion for the ball valve or the combination.
The lighter units can be carried by one
person alone or with the aid of an assis-
tant.
For heavier units you will need suitable
lifting gear to transport them.
You can transport the unit over dis-
tances of a few metres without pack-
aging.
Use the original packing when trans-
porting the unit over greater distances.
If the original packing is not available,
pack the unit so that it is protected
against corrosion and mechanical
damage.

Argus E25 MOD II Specifications

General

Brand	Argus
Model	E25 MOD II
Category	Controller
Language	English