Argus E25 MOD II User Manual

Argus E25 MOD II - Operating Instructions
16
In the event of delivery with a ball
valve/combination, make sure that the
optional components contain no liq-
uids and have been rinsed clean.
Attach lifting gear with adequate load
capacity.
Secure the unit (without ball
valve/combination) using suitable
slings on the body.
Secure the unit (with ball
valve/combination) using suitable
slings on the valve body. Please read
the separate operating instructions for
the valve for how to do this.
Make sure the included angle between
the legs of slings is not more than 60°.
Contact the manufacturer if space is
so restricted where the valve is locat-
ed that this type of transport is not
possible.
Installing and connecting the
unit
ATTENTION!
The
unit may only be installed,
removed,
maintained and con-
nected
by authorised persons.
Pleas
e contact the manufacturer if
it
is not possible to comply with
these
conditions.
Contact
the manufacturer if you
need
help with the installation,
connections
or commissioning of
the
unit.
Preparing for installation
Take the unit out of its transport pack-
ing.
Check the unit for transport damage.
If you find transport damage, contact
the manufacturer.
As delivered, the connections may be
closed with plugs.
Remove the plugs before installation.
Keep the plugs and packing materials
in a safe place for subsequent use.

Argus E25 MOD II Specifications

General

Brand	Argus
Model	E25 MOD II
Category	Controller
Language	English