Argus E25 MOD II User Manual

Argus E25 MOD II - Operating Instructions
39
CAUTION
Danger
of crushing injury if the
unit
falls or tips.

When dismounting the unit
employ suitable measures to
secure it against falling.
Suitable measures are, for example:
Having a second person to support
the unit.
In locations with restricted access,
support heavy units with lifting gear
with adequate load capacity.
Undo the unit’s connections to the
valve.
Lay the unit on a suitable surface.
WARNING
Danger
of injury from reaching
into
the unit.

Secure the unit during test
runs.
If necessary, dismantle the unit from the
valve on which it is installed.
Ensure that the valve and pipeline are
pressure-free.
When doing this, observe and follow
the instructions supplied for the valve.
Remove the valve together with the
actuator from the pipeline.
Store the combination of actuator and
valve on a suitable support.
Store the unit as described in the
section
“Storing the Actuator” .
Reusing the unit after storage
You can dismount the unit and reuse it at
another location if you observe the follow-
ing conditions:
Make sure there is no damage to
cable glands or electrical components
and cables.
Ensure that components subject to
wear are in flawless condition.
If necessary damaged components
must be replaced to return the unit to a
flawless condition.
Use the unit only for the same applica-
tion conditions as you would use a
new unit.
Disposal of the unit
ATTENTION!
Environmental
damage is possible
from
poisonous materials.

Before disposal make sure the
unit has been cleaned and is
free of poisonous substances.

Dispose of all materials in
accordance with the legal re-
quirements that apply where
the unit is installed.
For details of the materials used in the
unit, please contact the manufacturer.

Argus E25 MOD II Specifications

General

Brand	Argus
Model	E25 MOD II
Category	Controller
Language	English