FREEWAYCAM3/SMARTCAM3/SPEEDCAM3
User Manual
Adaptive Recognition America
Adaptive Recognition Hungary
Adaptive Recognition Nordic
Adaptive Recognition Singapore
WWW.ADAPTIVERECOGNITION.COM
Recommended settings:
• Overhead: Panning angle (α) will be zero, because the radar will be mounted above the lane
and it should only be tilted. The recommended setting in case of legally valid measurement: β
= 25°. Recommended setting in counting mode: β = 35°.
• Lateral: Tilting angle (β) will be zero, because the radar will be mounted using only panning.
The recommended setting in case of legally valid measurement: α = 20-25°. Recommended
setting for vehicle counting: α = 35°.
• Transversal: In case of this setting both angles are non-zero. Recommended on-site
installation: approximately 2 meters from the edge of the road, approximately 6 meters high.
The parameters can vary considerably depending on the on-site conditions. The
recommended setting in case of legally valid measurement (to cover one lane) constrains
the above by: α = 10-14° and β = 20° (α depends on the width of the lane).
•
Recommended setting for vehicle counting:
o
in case of covering one lane: α = 17° and β = 25°,
o
in case of covering two lanes: α = 14° and β = 15°.
A device intended to be suitable for legally valid measurements may be sealed read-only after
configuring its parameters. In this case “Skip config file” must be checked to prevent the system
from trying to modify the parameters. (This will always fail, resulting in dramatically increased boot
time). The “Radar device is sealed read-only” WARNING will appear in the log. (Only in Plain Config)
To Next Page
Loading...
