The subtitles added to the image are configured here.
In the Camera Constants tab users can assign a string to variables which will be printed according to
the value detected.
• Device ID string: Device identifier
• Device location string: Location identifier
• Approaching vehicle string: The string that gets printed in the subtitle when an approaching
vehicle is detected (only in models with speed measurement)
• Leaving vehicle string: The string that gets printed in the subtitle when a leaving vehicle is
detected (only in models with speed measurement)
• Unknown vehicle direction: The string that gets printed in the subtitle when vehicle direction
cannot be determined.
In the Line Editor tab users can customize the subtitle using the wildcards listed below.
To Next Page
Loading...
