ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 800.798.0813 • 2074140-INS-RA • PAGE 2
Step 1
Locate the three mounting points along
the bottom edge of the vehicle body.
Step 2
Starting on the driver side,
locate the front mounting point.
With help, lift the rocker step up to the
vehicle and secure using two M8 flat
washers and two M8 serrated flange
hex nuts.
Snug the hardware,
but do not fully tighten.
Step 3
Repeat step 2 to secure the middle and
rear mounting brackets to the vehicle.
With the rocker step in position,
tighten all mounting hardware to the
recommended torque specifications
listed in the table on the first page.
Step 4
Repeat steps 1 through 3 on the
passenger side of the vehicle.
Congratulations on the installation
of your new ARIES rocker steps.
With the rocker step installed, periodic
inspections should be performed to
ensure all mounting hardware
remains tight.
To Previous Page
Loading...
