64
ITGB
Back Enter
84
86
8 Service Param
85
88
89
Solar & Storage
Statistics
Service
Error History
Service Contact
Selection
of the statistical parameter
assistance parameters
- 84 Solar heating system & Indirect cyl-
inder
press the con rmation button and turn the
knob to select one of the following options:
840 Recorded storage tank temperature
841 Solar collector temperature
842 Domestic hot water inlet temperature
843 Lower indirect cylinder sensor
844 Indirect cylinder strati cation set T
845 Solar pump total ON time
846 Solar collector total overheat time
Turn the knob to change the value and press
the con rmation button. Press the exit button.
- 85 Service
press the con rmation button and turn the
knob to select one of the following options:
850 Months remaining until the next ser-
vice
851 Enable maintenance noti cation
852 Cancel noti cation
854 HW version P.C.B.
855 SW version P.C.B.
856 SW version BUS P.C.B.
Press the con rmation button to change the
value (for the rst three parameters), then
press the con rmation button. Press the exit
button to return to the previous screen. Turn
the knob and use the detail button to display
the remaining parameters. Press the exit but-
ton to return to the previous screen.
- 86 Statistics
press the con rmation button and turn the
knob to select one of the following options:
860 Hours heating burner on
861 Hours domestic hot water burner on
862 No. of ame cut-o s
863 No. of ignition cycles
864 No. of lling cycles
865 Average heat request duration
To Next Page
Loading...
