Ariston CLIMA MANAGER - Page 81

81
ITGB
3 03 PCB Fault No Reset
3 04 Too many resets No Reset
3 05 PCB Fault Reset
Display Description Restore
3 06 PCB Fault Reset
3 07 PCB Fault Reset
COMMUNICATION WITH PERIPHERAL UNITS
4 01 Mdm-Bus Com error No Reset
4 02 GPRS mdm error No Reset
4 03 Sim Card error No Reset
4 04 Mdm-PCB Com err No Reset
4 05 Mdm In1 error No Reset
4 06 Mdm In2 error No Reset
4 07 Room Sensor Open Circuit No Reset
IGNITION AND DETECTION
5 01 No  ame detected Reset
5 02 Flame Sensed with Gas Valve Closed No Reset
5 04 Flame lift No Reset
5 P1 1st Ignit Failed
5 P2 2nd Ignition Failed
5 P3 Flame lift
AIR INLET / FLUE GAS EXHAUST
6 01
Fumes Over ow
No Reset
6 02
6 04 Low fan speed Reset
6 07 APS on FAN o No Reset
6 10 Exchanger Probe Open Circuit Reset
6 12 Fan Error Reset
6 P1 APS late closing
6 P2 APS close-open
Restoring operation
The boiler is protected from malfunctions by means of internal checks performed by the P.C.B.,
which stops the boiler from operating if necessary. In the event of the boiler being shut o in this
manner, a code appears on the Clima Manager display which refers to the type of shut-o and the
reason behind it.
To restore normal boiler operation, press the Multi-functional reset button, which will restore the
optimal conditions. If this shutdown occurs frequently, contact an authorised Service Centre for
assistance.