13
3 OPERATING INSTRUCTIONS
To prevent contamination, use personal protective
equipment, such as gloves and protective glasses,
when handling soiled waste containers and
loading the goods into the usher-disinfector.
3.1 Program overview
Program Standard
Degree of soiling Heavily soiled
Program sequence Cleaning
Disinfection
Cooling
End of program
Program time 9-10 min
Energy 0.25 kWh
Water (including cooling) 39 l ± 10%
3.2 Run a program
3.2.1. Start a program
If the machine has not been used for more than
72 hours, it is necessary to run a program with an
empty chamber before using the machine to
clean goods.
1. Open the door. (Use the door sensor on the machine.)
2. Place the goods to be cleaned in the holder according to the
attached instructions.
3. If the holder has become stuck in the wrong position, press
(open door) to reset the holder to the starting position.
4. The door closes when a program is selected, or when the
door sensor is activated.
5. The yellow light under will blink for 6 seconds and during the
time it is possible to abort the program.
To Next Page
Loading...
