Setting Capture Options
ARM DUI 0482K Copyright © 2010-2012 ARM. All rights reserved. 4-3
ID120712 Non-Confidential
4.2 Capture options
The Capture Options dialog box presents various options that you can use to customize a capture
session.
Figure 4-3 Configuration options
4.2.1 Connection and Capture settings
The Connection and Capture sections contains the following settings:
Address The network address of the target. You can also enter the network name of your
target here. The value given in this field overwrites the value in the Address field
of the Streamline Data view, if one has been given. The reverse is also true. If you
enter a new address in the Address field of the Streamline data view, it replaces
the value entered here.
By default, Streamline uses port 8080 to connect to a target. To use a different
port, specify one here by entering a colon and a port number after the IP address.
For example, enter
Your_IP_address:1010
to use port 1010 to connect to the target.
If you use the port forwarding of ADB with USB, enter
localhost
in the Address
field.
To Next Page
Loading...
