Setting Capture Options
ARM DUI 0482K Copyright © 2010-2012 ARM. All rights reserved. 4-5
ID120712 Non-Confidential
It might be necessary to specify the
tty
device in the Device field when using
Streamline on Linux. To do so, enter the following command in the Device field:
/dev/ttyACM0.
Tool Path Use this field to define the path to the
caiman.exe
executable, necessary to use the
ARM Energy Probe to gather power output statistics. The button to the right of
this field enables you to search your file system:
Figure 4-4 The Tool Path dialog box
In addition to the settings that define your capture device, the Energy Probe section has
configuration options that apply to each channel:
Power When checked, Streamline collects power data on this channel.
Voltage Check this box to collect voltage data on this channel.
Current When this option enabled, Streamline collects current information for the chosen
channel.
Resistance Use this field to define the value, in milliohms, of the shunt resistor that connects
to each of the available channels. The default setting is 20 milliohms.
For more information on setting up the Energy Probe, see Energy Probe setup on page 12-5.
4.2.3 Analysis options
The Analysis section contains the following controls:
Process Debug Information checkbox
If you select this checkbox, Streamline processes dwarf debug information and
line numbers. This provides a higher level of detail in your Analysis Reports, but
results in higher memory usage. This option does not affect the data collected
To Next Page
Loading...
