System problem (I2C
bus error)
Problem on camera data bus. Reboot the
camera. If error continues to occur, contact
ARRI service.
External TC:
Incompatible frame
rate
The external TC signal's time base is not
accepted by the camera.
HD outs not synced.
Trigger now.
Appears on slave cam with Ext sync
activated, but not using settings sync. Send
trigger from Ext sync master camera to
ensure the REC OUTs of both cameras are
in sync.
Connect with
Ethernet slave.
Camera is set to Settings sync: Enet master,
but is not connected with slave camera via
Ethernet
Connect with
Ethernet master.
Camera is set to Settings sync: Enet slave,
but is not connected with master camera via
Ethernet
External TC:
Jamming. Please
wait.
Camera jams to external TC signal. Do not
disconnect TC source from camera until
warning disappears.
External TC: Signal
missing
Camera is set to Ext LTC regen, but external
TC signal is missing.
External TC:
Incompatible frame
rate
The external TC signal has a time base that
does not match the project fps of the
camera.
Framegrab: Grabbing
image failed
A problem occured in the camera. The
frame grab failed.
Framegrab: Storing
image failed
A problem occured with the SD card. The
frame grab failed.
Playback failed The camera could not play back the
internally recorded clips.
EVF smooth mode
not possible
Smooth mode is set to "On", but either
sensor fps is higher then 30.000, or shutter
angle is higher than 180.0
Ext LTC: Forced to
JAM sync
Ext LTC had to be switched to Jam sync by
camera system.
Playback failed A problem with playback occured. Camera
had to abort playback.
Card/Media
removed, playback
failed
Camera had to abort playback, as media
was removed.
Calibrate lens
motors.
New lens motors are attached to the
camera. Prior to use they must be
calibrated.
To Next Page
Loading...
