36 Using your ViasatHD box
◆ Once the scan is complete, a list of all available TV and radio channels appear on
your screen. To select your preferred channels, use U or D to highlight them and
press OK. To select all the available channels, press green and then press OK.
Press red to clear all the highlighted channels.
◆ To save the selected channels, you can either press yellow to replace all existing
free-to-air channels, or blue to append the new channels to your existing
channel list.
◆ Press back to exit the menu.
To delete any free-to-air channel, go to Settings > System Setup > Free-To-Air channels >
Satellite Free-To-Air. On this screen :
◆ Use U or D to highlight ‘Delete Channels’ and press OK. From the list of
channels that appears, use U or D to highlight the channel you want to delete
and press OK to select it. Press red to delete the selected channel.
◆ To delete all the channels, use U or D to highlight ‘Delete All Channels’ and
press OK. In the screen that pops up, use U or D to highlight Ye s and press OK
to confirm the deletion.
SCART Setup
You use this screen to choose the type of video signal that is output on the mini DIN
connector (marked A/V on your box’s rear panel).
◆ Select the TV SCART output you want (RGB or Composite).
Resolution Setup
You can use this screen to choose the video resolution that is output from your box’s
HDMI connector (only if an HD TV is connected).
◆ Select the resolution you want (720p or 1080i)
Note
After you press blue, your box temporarily changes the resolution. You must confirm the change
within 30 seconds. Highlight APPLY or CANCEL then press OK.
Settings
To Next Page
Loading...
