Programming Your Audio Device by Code
1. Turn on your Audio device.
2. Repeat steps 2. to 4. in the “Programming Your TV by Code” section above, but use the setup codes listed for
your Audio brand.
Programming Your Audio Device or TV by Search
1. ITurn on your TV and Audio devices.
2. In front of your TV and Audio devices, press and hold the MOXI and OK buttons on your remote together until
the red LED at the top of the remote blinks 2-times. Release both buttons after the red LED blinks as indicated.
3. Slowly press the Ch + button repeatedly,which will cycle through potential remote codes. Continue pressing it
until you find a code that turns off your TV or Audio device off. As soon as your TV or Audio device turns off, stop
pressing the Ch + button.
4. Press Mute. If your TV or Audio device:
Turns back on, press OK to lock in the code. The red LED at the top of the remote will blink 2-times.
Does not turn back on, you may have gone past the correct code. Press the ch - button one step at a time until
you find a code that turns your TV or Audio device back on. Once you have found a code that turns your TV or
Audio device on and off, press OK to lock in the code. The red LED at the top of the remote blinks 2-times.
5. Repeat steps 2 – 5 above to program your second electronic device, TV or Audio.
Some older devices may not be supported. If the device fails to respond to any code, use its original remote to
control it.
To reset the Moxi remote to the original factory settings:
Press the Moxi plus OK buttons simultaneously and hold until the LED light on the top of the remote blinks twice,
and then press clear, clear, clear.
110
Feature Setup
To Next Page
Loading...
Need help?
General
