To Next PageTo Next Page
Need help?Do you have a question about the Art SLA-1 and is the answer not in the manual?
Power| power requirement USA | 120VAC 60Hz 600WATTS(max.) |
|---|---|
| power requirement JAPAN | 100VAC 50Hz 600WATTS(max.) |
| power requirement EUROPE | 220VAC 50Hz 600WATTS(max.) |
| power requirement AUSTRALIA | 240VAC 50Hz 600WATTS(max.) |
Output Power| stereo output power 8 ohms | 100Watts RMS per Channel |
|---|---|
| stereo output power 4 ohms | 130Watts RMS per Channel |
| stereo output power 16 ohms | 55Watts RMS per Channel |
| bridged output power 8 ohms | 260Watts RMS mono |
| bridged output power 16 ohms | 175Watts RMS mono |
Electrical Characteristics| frequency response | 10Hz to 40kHz, +/- .5dB |
|---|---|
| total harmonic distortion (THD) | <0.05% (typical) |
| slew rate | >20V/uS |
| damping factor | >100 |
| CMRR | >60dB (typical @ 1kHz) |
| hum and noise | >100dB below clipping |
Weight and Dimensions| height | 1.75 inches |
|---|---|
| width | 19.0 inches |
| depth | 9.5 inches |
| weight | 13.2 lbs, 6.0 kg |
Essential safety warnings and guidelines for operating the amplifier.
Covers power, ventilation, moisture, heat, and environmental considerations.
Proper handling, transit protection, and service referral advice.
Connecting the unit to mains power supply (115 VAC @ 50-60 Hz).
Details on balanced XLR and 1/4" input connections.
Warnings regarding speaker loads and impedance for safe operation.
Controls for power on/off and volume adjustment for channels.
Explains the Signal, Clip, and Protect LEDs.
Details on balanced XLR and 1/4" input options for connecting sources.
Wiring details for 1/4" jacks (Tip, Ring, Sleeve).
Wiring details for XLR jacks (Pin 1, 2, 3).
Select between Stereo and Bridge Mono modes for operation.
Details on connecting speakers using bare wire, spade, or banana plugs.
Description of the thermal-dependent cooling system.
Information on the 7 Amp fuse and replacement.
Connecting the detachable power cable to the correct voltage outlet.
Function of the switch to disconnect chassis ground for noise reduction.
Step-by-step guide for stereo setup and volume adjustment.
Instructions for connecting and operating in bridge mono mode.
Details the three-year warranty on workmanship and materials.
Conditions under which the warranty is voided or does not apply.
