2
Additional Information
Lethal voltages and currents are present at the input terminals of
this device. Accordingly, this AMT Toolkit should be installed and
maintained only by qualified, competent personnel who have the
necessary training and experience appropriate to high voltage and
current devices. AMT Toolkit must be used in accordance with all
local and national codes for the installation and operation of
electrical equipment. Observe all site-specific procedures including
local lockout and tagout.
Recommended safety precautions should be followed at all times.
Both current and voltage transformers can present lethal currents
and voltages when their primaries are energized and standard
practices (i.e. shorting the secondaries of current transformers
and removing voltage transformer fuses) must be respected
during installation or any subsequent service.
Disclaimer
Maintenance planning information as well as its timing is issued based on the observations
in the field and is approximate and considers the average behavior of different types of
equipment. Since each piece of equipment and conditions under which it runs may be
different, actual failure periods may be different. Therefore, it is recommended that
maintenance actions and their timing indicated in the AMT Condition Assessment Report
should be used only as a guide and the indicated abnormalities should be checked and
remedied as soon as feasible.
Product Disposal Statement
Customers and third parties, who are not member states of the European Union, who are in
control of the product at the end of its life or at the end of its use, are solely responsible for
the proper disposal of the product. No person, firm, corporation, association or agency that
is in control of product shall dispose of it in a manner that is in violation of any applicable
federal, state, local or international law. Artesis is not responsible for the disposal of the
product at the end of its life or at the end of its use.
To Next Page
Loading...