Artesis AMT Toolkit - Warning Conditions

Appendices
53
7.1.3. Warning Conditions
Warning
Number
Warning Type
Description
0x01
Test frequency
range
(MONITOR, IMPROVE, UPDATE only) The
measured frequency was different than (i.e.
outside the threshold of) the LEARN frequency
0x02
Residual error
An unexpectedly large value was calculated for
the modeling error. This is generally an indication
of an unstable line condition and will usually pass
0x04
Data size reset
Values for some quantities were checked and
found to be outside their allowable limits. The
values were reset to the upper or lower limits
0x08
Phase ordering
Phase ordering is different from the values set
0x10
Unstable system
Instability was detected for the system