6.3. Copy Drum to Drum
The following procedures were covered extensively here [p.48]:
• To copy an instrument track to another instrument within the same pattern, see
this section [p.48].
• To copy an instrument track into a different pattern in the same bank, follow
these instructions [p.49].
• To copy an instrument track into a pattern in a different bank, read this section
[p.49].
6.4. Erasing a Bank
To erase all 16 patterns in a bank:
• Be sure you know which bank you want to erase. This process cannot be undone.
• Press the Erase button. Lots of buttons and pads will flash.
• Press the Bank button. The Step button for the currently selected bank will flash.
• Use the Step buttons to select the bank you want to erase. It will flash rapidly for
about a second.
When the flashing stops, the process is complete.
6.5. Erasing a Pattern
To erase one of the patterns in a bank:
• Be sure you know which pattern you want to erase. This process cannot be
undone.
• Press the Erase button. Lots of buttons and pads will flash.
• Press the Ptrn button. The Step button for the currently selected pattern will flash.
• Use the Step buttons to select the pattern you want to erase. It will flash rapidly
for about half of a second.
When the flashing stops, the process is complete.
6.6. Erasing a DrumTrack
This process was covered in section [p.50]. Here are the highlights:
• Press the Erase button. Lots of buttons will flash.
• Tap the pad of the drum track you want to erase. It will flash quickly and then
stop, so you will know the process is complete.
61 Arturia - User Manual DrumBrute Impact - Copy/Erase Functions
To Next Page