Aruba 7030 - Aruba 7030 Controller Installation Guide; Installation Safety Precautions

Aruba 7030 Mobility Controller | Installation Guide Installation | 17
Chapter 2
Installation
This chapter describes how to install an Aruba 7030 controller using the many mounting options available.
The 7030 controller ships with an accessory kit that includes the equipment needed to install the controller
in standard, 19-inch telco rack or on a wall.
 “Precautions” on page15
 “Selecting a Location” on page16
 “Rack Mounting- Standard” on page16
 “Table or Shelf Installation” on page18
 “Wall Mounting” on page18
 “Installing an SFP” on page20
Precautions
 Ensure that the rack is correctly and securely installed to prevent it from falling or becoming unstable.
 Dangerous voltage above 240VAC is always present while the Aruba Power Supply Module is plugged
into an electrical outlet. Remove all rings, jewelry, and other potentially conductive material before
working with this device.
 Never insert foreign objects into the chassis, power supply, or any other component, even when the
power supply is turned Off, unplugged, or removed.
 Ensure that the main power is fully disconnected from the controller by unplugging all power cords
from their outlets. For safety, verify that the power outlets and plugs are easily reachable by the
operator.
 Do not handle electrical cables which are not insulated. This also includes network cables.
 Keep water and other fluids away from the controller to minimize electrical hazards.
 Comply with electrical grounding standards during all phases of installation and operation of the
product. Do not allow the controller’s chassis, network ports, power supply, or mounting brackets to
contact any device, cable, object, or person attached to a different electrical ground. Also, never connect
the device to external storm grounding sources.
 Perform installation or removal of the chassis or any module in a static-free environment. Proper use of
anti-static body straps and mats is strongly recommended.
Installation of the device should be performed by a trained installation professional.
Please only use the included or Aruba specified cables, power cords, AC power supplies, and batteries. The power
cord should not be used with other electric equipment than what is specified by Aruba.
接続ケーブル、電源コード、AC アダプタ、バッテリーなどの部品は、必ず添付品または指定品をご使用ください。
また、電源ケーブルは弊社が指定する製品以外の電気機器には使用できないためご注意ください。