18
RESET FUNCTION (option 010 606)
The RESET function helds output pressure at 0 bar, as long as pin L stays in logic value 0.
As long as pin L (ENABLE) is maintain at logic value 0, the valve output pressure remains at 0 bar.
All bit combination settings at the input are ignored and the valve remains at 0 bar.
If pin L (ENABLE) goes to logic value 1, the output pressure is updated in relation to the input binary combination given at
that moment. If the bits combination changes and if pin L (ENABLE) is held at logic 1, the valve output pressure is modified
in relation to this new combination.
As long as the enable line is held at "low", the output pressure is 0 bar, and all data is ignored.
If the enable line is held at "high", the output pressure is updated according to the bit combination at the input.
Output pressure
at 0 bar
Enable
Set point
To Next Page
Loading...
Need help?
General
