24
This product contains electronic components sensitive to
electrostatic discharge. If a person or an object come in contact
with the electrical components of the product, there will be an
electrostatic charge which can damage or destroy the product.
To reduce the risk of electrostatic discharge, please observe the
handling precautions and recommendations contained in standard
EN100 015-1 at all times. Do not connect or disconnect this device
when it is energised.
ESD
WARNING
OBSERVE PRECAUTIONS
FOR HANDLING
ELECTROSTATIC
DISCHARGE
SENSITIVE DEVICES
POSITION OF POTENTIOMETERS AND JUMPERS
SENTRONIC G 1/8, G 1/4, G 1/2, G 1
Remove the lid of the body by unscrewing the 4 screws. Caution : do not loosen or damage the cable
connections, and adjust the potentiometer.
P2
P1
P6
P7
P5
P4
max.
P1 = Span adjustment
P2 = Offset adjustment
P4-P5 = Calibration of pressure sensor : DO NOT MODIFY THIS ADJUSTMENT
P6 = Pressure switch adjustment (window size)(1,4 . . . 6%)
P7 = Proportional gain (1. . .11)
Coil
PNEUMATIC CONNECTION
The pneumatic ports are as follows : 1 = supply pressure, 2 = pressure output, 3 = exhaust
Each screw connection is lined with a fitting synthetic sealing disc. PTFE (polytetrafluoroethylene) sealing tape
and hemp should not be used as they may get into the inside of the valve and damage it. Use an appropriate
silencer at port (3). The exhaust time can be longer according to the type of silencer you use.
The diameter of the pneumatic lines must be adjusted to the nominal diameter of the valve. the diameter of
output line (2) must be larger or equal to that of input line (1).
The supply pressure must always be less than the MAP value (max. allowable pressure).
Sentronic with internal
control of the pressure sensor
Sentronic with external
control of the pressure sensor
5M-1002
To Previous Page
Loading...
