19
Customer Care Center 1-800-898-1879 www.askousa.com
1. Check that all parts are correctly fitted. If
not, go through the steps again.
2. Ensure that all packaging materials have
been disposed of.
3. Use a mild dishwashing detergent with
warm water and wash the drying cabinet
both inside and out. Wipe thoroughly. For
further information, see the section “Care”
section later in this manual.
4. Insert the power plug.
5. Turn the heat control to “Normal” (full heat)
and the time switch to about 20 minutes.
Next, press “START”.
6. Read the section “Operation”, later in this
manual.
If the drying cabinet does not start,
check the following:
- That the drying cabinet door is
closed.
- That the heat control and time switches
are activated.
- That the “START” button has been fully
depressed .
- That the drying cabinet is connected
to the wall outlet.
- That the house breaker has not
tripped.
7. When the drying cabinet has been on for
five minutes, open the door and check if it
is warm inside the cabinet.
If the cabinet is not producing heat,
even though the heat control is acti-
vated and the fan is running, turn the
time switch back to “0” and wait 30
minutes.
After 30 minutes, try to start the unit
by turning the time knob to the desired
program time, and the temperature
knob to “Normal”.
Next, press the “Start” button.
For further information, see the section
“Troubleshooting”.
Final inspection
To Next Page
Loading...
