20
Customer Care Center 1-800-898-1879 www.askousa.com
Operation instructions
Starting your drying cabinet
1. Place laundry in the drying cabinet and
close the door. For further information, see
the section “Loading”.
2. Set an appropriate temperature and drying
time. See the section “Cycles”.
3. Press the “START” button.
Stopping your drying cabinet
Open the door and set the time switch to
“0”.
Pausing or restarting
Pause: Open the door.
Restart: Close the door and press the
“START” button.
Loading
There are three sections with hangers in the
cabinet. Each section has a number of rods
for hanging items.
The optimized hanging system has remov-
able hangers, which facilitates hanging and
removal of items, and also makes it easier on
the back and shoulders.
Hang the items in the drying cabinet
based on the space required – not on
weight.
For optimal performance, do not place
flat-dry items on the upper hanger sec-
tion.
Long articles are hung close to the cabi-
net walls and shorter towards the center.
By hanging the items in this way, the best
drying results are attained.
Fold up the two lower hanger sections
when drying long articles.
Hang gloves, caps, scarves and similar
articles on the hanger rack on the inside
of the door.
Pull out the hanger hooks in the upper
section to facilitate hanging wash. Push
them back in when not in use.
Do not overfill the drying cabinet. The
items will wrinkle and drying will be un-
even. Instead, try to leave space between
the articles.
If there is a risk of some articles staining,
be sure to leave space around them.
If you have paused the drying process,
the drying cabinet continues from the
position of the time switch when the
drying cycle was stopped. If you want
to stop drying completely, turn the
time switch to “0”.
To reduce the risk of electric shock or
injury to persons, read the ‘Important
Safety Instructions’ on page 4 before
operating this appliance.
Warning!
To Next Page
Loading...
