Troubleshooting
311139B 23
Troubleshooting
Check everything in this Troubleshooting Table before you bring the sprayer to an ASM authorized service center.
Refer to Component Identification, page 6, for reference letters used in table.
Problem Cause Solution
Power switch is on and sprayer is
plugged in, but motor does not run,
and pump does not cycle.
Pressure is set at zero pressure. Turn Pressure Control Knob (C)
clockwise to increase pressure set-
ting.
Motor or control is damaged. Take sprayer to ASM authorized ser-
vice center.
Electric outlet is not providing power. • Try a different outlet or plug in
something that you know is work-
ing to test outlet.
• Reset building circuit breaker or
replace fuse.
Extension cord is damaged. Replace extension cord. Read
Grounding and Electric Require-
ments, page 5.
Sprayer electric cord is damaged. Check for broken insulation or wires.
Replace electric cord if damaged.
Paint is frozen or hardened in pump. Unplug sprayer from outlet.
If frozen do NOT try to start sprayer
until it is completely thawed or you
may damage the motor, control board
and/or drivetrain.
Make sure power switch is OFF.
Place sprayer in a warm area for sev-
eral hours. Then plug in and turn ON.
Slowly increase pressure setting to
see if motor will start.
If paint is hardened in sprayer, pump
packings, valves, drivetrain or pres-
sure switch may need to be replaced.
Take sprayer to ASM authorized ser-
vice center.
To Next Page
Loading...
