ASM Zip-Spray ESP - Oil- or Water-Based Materials

Priming
10 311139B
Priming
Oil- or Water-based Materials
1. Turn Spray-Prime/Drain valve
to PRIME.
2. Separate prime tube
(smaller) from suction tube
(larger).
3. Place prime tube in waste
pail.
4. If spraying oil-based
materials, submerge suction
tube in mineral spirits or compatible oil-based clean-
ing solvent.
If spraying water-based
materials, submerge suc-
tion tube in water.
5. Plug sprayer in to grounded outlet.
6. Point gun into waste pail.
7. Turn power switch ON.
8. Increase pressure, by turn-
ing Pressure Control knob
clockwise, until pump starts.
9. Allow fluid to flow out of prime tube, into waste pail
for 30 to 60 seconds.
10. Turn power switch OFF.
To spray water-based materials after spraying
oil-based materials, flush the system thoroughly
with water first. The water flowing out of prime tube
should be clear and solvent-free before you begin
spraying the water-based material.
To spray oil-based materials after spraying
water-based materials, flush the system thor-
oughly with mineral spirits or a compatible
oil-based flushing solvent first. The solvent flowing
out of the prime tube should not contain any water.
• When spraying with solvents, ground gun. Read
Grounding and Electric Requirements, Maintaining
grounding continuity, page 5.
• To avoid fluid splashing back on your skin or into
your eyes, always aim gun at inside wall of pail.
35,0(
WLD
:$67(
3$,/
7,D
TIAB
WLD
WLD
WLD