54
Adjust LEDs according to the LED pattern (=address).
The following applies for each LED:
LED is lit: Address value is selected
LED is dark: Address value is de-selected
You always select or de-select the address value when the status of the
corresponding LED changes. You must turn the key switch briefly to the
right for this purpose.
Select the address value.
Immediately when the corresponding LED illuminates:
Briefly turn the key to the right.
De-select the address value:
Immediately when the corresponding LED goes out:
Briefly turn the key to the right.
The cycle begins again for LED1 after each selection.
You have several attempts to select and/or de-select the LEDs.
If you do not select or de-select anything, the process cycles up to LED 64.
Then you hear an audible signal and the process starts again with LED 1.
Step 4
To Next Page
