4 of 8
Install the Strike Plate
1 Using a hammer, TAP the roll pins into the
strike plate until seated. Protect face of strike
to prevent damage. (see Diagram 9).
2 INSERT the 5/16-18 bolt through the funnel
bushing and strike plate (see Diagram 10).
3 APPLY thread lock to the 5/16-18
bolt threads (see Diagram 12).
4 INSTALL 2 or 3 rubber washers on the 5/16-18 bolt.
5 INSTALL the roll pin bushings into
the door (see Diagram 11).
6 From the outside of the door, gently
TAP the sex bolt into place.
NOTE: The strike plate is secured to the
door via the supplied sex bolt.
7 INSTALL the strike by aligning it with the sex
bolt and roll pin bushing and then tightening
the center screw (see Diagram 12).
NOTE: The center screw should not be
over tightened; strike should float.
DOOR
FRAME
TOP OF
DOOR FRAME
DOOR
Roll Pin Bushings
Blind Nuts
Sex Bolt Hole
DOOR
THREAD
LOCK
Funnel Bushing
Washers
5/16-18 Bolt
STRIKE PLATE
Diagram 9 Seating the Roll Pins
Diagram 11 Install the
Bushings in the Door
Diagram 12 Tap Sex Bolt into door (outside).
Align sex bolt with roll pin bushing.
Diagram 10 Install the Bolt through funnel in Strike Plate
To Next Page
Loading...
