3.INSTALLATION AND CONNECTION
12
Further Guidelines for installation of Heat Pumps
ASTRAL POOL Heat Pumps must be installed outdoors – never install inside a plant room, garage etc.
Allow a minimum of 500mm clearance from the sides and rear of the heat pump and a minimum of 1000mm service access from
the front of the Heat Pump.
Ensure an electrical isolation switch is located nearby the Heat Pump.
On Three Phase models, ensure the phase rotation of the compressor is checked before commissioning of the unit.
Ensure the water pressure switch operation is checked at least 6 times prior to handing over the Heat Pump.
Refer to Installation and Operating Instructions for full installation, commissioning and operating procedures.
To Next Page
Loading...
