2-28 Chapter 2: BIOS setup
Power On By PS/2 Mouse [Disabled]
When set to [Enabled], this parameter allows you to use the PS/2 mouse to turn on
the system. This feature requires an ATX power supply that provides at least 1A on
the +5VSB lead.
Conguration options: [Disabled] [Enabled]
2.5.6 Hardware Monitor
Hardware Monitor
CPU Temperature [55.5ºC/131.5ºF]
CPU Fan Speed [4440RPM]
CPU Q-Fan Control [Disabled]
Chassis Fan Speed [N/A]
VCORE Voltage [ 1.336V]
3.3V Voltage [ 3.323V]
5V Voltage [ 5.145V]
12V Voltage [11.880V]
CPU Temperature [xxxºC/xxxºF]
The onboard hardware monitor automatically detects and displays the motherboard
and CPU temperatures. Select Ignored if you do not wish to display the detected
temperatures.
CPU Fan Speed (RPM) [xxxxRPM] or [N/A] or [Ignored]
The onboard hardware monitor automatically detects and displays the CPU
fan speed in rotations per minute (RPM). If the fan is not connected to the
motherboard, the eld shows N/A. Select Ignored if you do not wish to display the
detected speed.
CPU Q-Fan Control [Disabled]
Allows you to enable or disable the Q-Fan control.
Conguration options: [Disabled] [Enabled]
CPU Temperature
To Next Page
Loading...
Need help?
General
