Asus TS110-E8-PI4 - Page 36

Chapter 2: Hardware setup
2-16
Installing 2.5-inch HDD/SSD
To install a 2.5-inch HDD/SSD:
1. Remove the side cover of the chassis. Refer to the
Removing the side cover
section
for more information.
2. Prepare the 2.5-inch HDD/SDD and the bundled set of screws.
3. Laythesystemonitssideonaatandstablesurface.
4. LocatetheHDDcagelock,pressitup(A),thenswingtheHDDcageoutwards(B).
5. Align and insert the 2.5-inch HDD/SSD into the drive bay as shown. Push it all the
way until its screw holes align with the holes on the drive bay.
HDD cage lock
HDD cage
matching screw holes
2.5-inch HDD/SSD