4-16
Chapter 4: BIOS setup
4.4.3 SATA Configuration
WhileenteringSetup,theBIOSautomaticallydetectsthepresenceofSATAdevices.The
SATA Port items show Not Present if no SATA device is installed to the corresponding SATA
port.
SATA Controller(s) [Enabled]
ThisallowsyoutoenableordisabletheSATADevice.Congurationoptions:[Enabled]
[Disabled]
SATA Mode Selection [AHCI]
ThisallowsyoutochoosehowSATAcontroller(s)shouldoperate.Congurationoptions:
[AHCI][IDE][RAID]
S.M.A.R.T. Status Check [Enabled]
Self-Monitoring,Analysis,andReportingTechnology(S.M.A.R.T.)isamonitorsystem.When
read/writeofyourharddiskerrorsoccur,thisfeatureallowstheharddisktoreportwarning
messagesduringthePOST.Congurationoptions:[Enabled][Disabled]
Aptio Setup Utility - Copyright (C) 2014 American Megatrends, Inc.
Advanced
SATA Controller(s) [Enabled]
SATA Mode Selection [AHCI]
S.M.A.R.T. Status Check [Enabled]
Serial ATA Port 0 HardDisk (250.0GB)
Software Preserve SUPPORTED
Port 0 [Enabled]
Hot Plug [Enabled]
SATA Device Type [Hard Disk Drive]
Spin Up Device [Disabled]
Serial ATA Port 1 HardDisk (250.0GB)
Software Preserve SUPPORTED
Port 1 [Enabled]
Hot Plug [Enabled]
SATA Device Type [Hard Disk Driver]
Spin Up Device [Disabled]
Serial ATA Port 2 HardDisk (250.0GB)
Software Preserve SUPPORTED
Port 2 [Enabled]
Hot Plug [Enabled]
SATA Device Type [Hard Disk Driver]
Spin Up Device [Disabled]
Enable or disable SATA
Device.
Aptio Setup Utility - Copyright (C) 2014 American Megatrends, Inc.
Advanced
Control Detection of the
Azalia device. Disabled =
Azalia will be unconditionally
disabled Enabled = Azalia will
be unconditionally Enabled
Auto = Azalia will be
enabled if present, disabled
otherwise.
PCH Azalia Conguration
Azalia [Auto]
PCH Azalia Configuration
AllowsyoutocontrolthedetectionoftheAzaliadevice.Congurationoptions:
[Auto][Disabled]