EasyManua.ls Logo

Asyst Technologies Advantag 9100 - Attribute Values (ECID and SVID)

Asyst Technologies Advantag 9100
51 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Rev. AX5 Draft Page 17
AdvanTag 9100 Technical Manual
Chapter 2: Theory of Operation
Data Storage—AdvanTag Reader
a
Read STATE Request - This message will query the CIDRW state of the transition
model.
ASCII communication:
Are You There - This message is used to perform the heartbeat between the host
and the connected device.
Read Attribute Request - This message requests the current values of ECID or
SVID of the subsystem component indicated in TargetID.
Read Data Request - This message reads the “NOTEPAD” (Linear Memory) sec-
tion of the subsystem component indicated in TargetID.
Write Data Request - This message writes data to the NOTEPAD section of the
subsystem component indicted in TargetID.
Read Material ID Request - This message is used to request the subsystem indi-
cated by TargetID to read an MID.
Write Material ID Request -This message is used to request the subsystem indi-
cated by TargerID to write Material identifier
Subsystem Command Request - This message is used to request the subsystem
indicated in TargetID to perform a specific action. Included in this set are the fol-
lowing commands: SSCMD 04 - Blink LED on Node/Device; SSCMD 07 - Perform
Diagnostics; SSCMD 13 - Reset; SSCMD 15 - Change State; SSCMD GetStatus.
Event Report Send - This message is used to send events to the host. Included in
this set are the following commands: CEID 01 - Material (Pod/Cassette) Arrival
Event; CEID 02 Material (pod/Cassette) Removal Event; CEID 03 - Operator
Arrival Event; CEID 04 - Operator Leaving Event; CEID 08 - AdvanTag/LinkMan-
ager Power up.
Read STATE Request - This message will query the CIDRW state of the transition
model.
Attribute Values:
T
ABLE 3 Attribute Values (ECID and SVID)
Attribute Description and Limits or Values
AlarmStatus The Alarm Status
Value = 0 or 1
CarrierIDOffset 0 to CID_MAX_LENGTH-1
CarrierIDOffset + CarrierIDLength <=
CID_MAX_LENGTH
CarrierIDLength 1 to CID_MAX_LENGTH
CarrierIDOffset + CarrierIDLength <=
CID_MAX_LENGTH
CID_MAX_LENGTH (8*N) N = Page1 to 17

Table of Contents