Viale del Lavoro, 19 37030 Colognola ai Colli (Verona) Italy
Tel. ++39 045 6159411- Fax ++39 045 6159422 - e-mail: info@at-os.com – www.at-os.com
41
DUMP SINK WASHING key
Rinsing with blended water for dump sink washing
RESET key
It restores machine operating functions after stoppage caused by an
alarm.
SOLVENT key (optional)
Upon pressing before selecting program a solvent liquid will be sprayed on
the bedpan in order to remove zinc creme left over.
The RESET key is inactive during the wash cycle to prevent the machine from being
stopped before the items have been disinfected (thermal model only).
To operate the machine just select the program on the control panel by pressing the key related to the desired cycle: normal,
reduced, intensive or rinse. Now the machine works automatically, locks the door opening and starts the selected cycle. In case of
failure the machine stops automatically and the display shows the cause that interrupts the wash cycle.
Once the wash cycle is terminated just open the door and remove the material that has been washed.
vents the door from being opened until the temperature inside the basin
is lower than 75°C and the temperature inside the steam generator is lower than the boiling
temperature of water. Those models, which are not set for final rinse, are equipped with a
different safety device that prevents the door from being opened until the temperature of
the instruments have cooled down in order to avoid danger to users.
11.3 Loading and unloading
The machine is normally furnished with a standard support (for example on picture F page III appendix I). This support can be used
to wash most of the bedpans and urinals used in hospital wards. AT-OS S.r.l. can furnish, on request, other supports that can be
interchanged with the standard support and can be used to wash bowls, large bottles and bedpans with a wide variety of shapes.
The instructions for these supports are furnished together with the support itself.
It is good practice to always check that the containers introduced in the wash chamber are suitable for the type of support that you
have. To check this make sure that the items introduced are sufficiently firm on their support so that they remain in their housing
without changing position when the door is closed.
Each country uses its own types of container and consequently containers may have different physical characteristics. As a
consequence not all types of support may be suited for washing your containers.
The illustrations on pages 25 and 26 show a few examples of bedpan hook/supports that AT-OS S.r.l. can supply. This system of
supports permits the machine to automatically empty, wash and disinfect (thermal model only) the bedpans.
Each support has instructions regarding the specific use for which it is designed. These instructions are attached to the
documents furnished with the machine or to the support itself.
Correct positioning of the items to be processed is fundamental for achieving a correct wash.
After loading the items to be washed (as described in the instructions given with the support) the machine's wash cycle can be
started, selecting on the control panel the program that best suits the items that have been introduced into the appliance.
11.3.1 Removing the bedpan hook/support
Sometimes it may be necessary to remove the bedpan hook/support to replace it or to perform routine or extraordinary maintenance.
To remove the support just pull it towards yourself until the support connections are released from their two anchor plates. To
reinsert the support perform this operation in reverse order (see pictures F and G on page III appendix I).
Whenever a new support is inserted make sure it is correctly fastened to its connections
(Position A, picture G on page III appendix I).
To Next Page
Loading...
