Atag DW7114SXB - User Manual

Questions and Answers:

P
paulmooreSep 10, 2025
Why are there spots on my stainless steel or silver after using my Atag DW7114SXB Dishwasher?
- T
  Tina MedinaSep 12, 2025
  If you're seeing spots on your stainless steel or silver items after washing them in your Atag dishwasher: * Some foods like mustard, mayonnaise, lemon, vinegar, salt, and dressings can cause spots if left on the items for too long. Rinse off these types of foods if you're not starting the dishwasher immediately. You can use the Rinse and hold program. * Contact between stainless steel and silver during dishwashing can cause spots. Aluminum can also cause spots on dishes. Separate dishes made from different metals, such as silver, stainless steel, and aluminum, to avoid marks and tarnishing.
A
Andrew JohnsonAug 22, 2025
What to do if my Atag DW7114SXB Dishwasher does not start?
- T
  Tyler PadillaAug 23, 2025
  The Atag Dishwasher may not start because the Start/Stop start button has been pressed for too short a time. Press and hold Start/Stop until the display shows "Program started, close door". Ensure that the door is properly closed and that the door lock has clicked into place and locked. Also, a fuse/circuit breaker may have been tripped, the plug may not be plugged into the wall socket, or the water tap may be turned off. Check these items. There may be overflow/leaks. Check for these issues. If a whirring sound (the drainage pump) is heard from the dishwasher and does not stop when the main power switch is turned off, turn off the water tap, pull out the plug and call the service department. If you want to cancel the Delayed Start option, press and hold Start/Stop for three seconds.
W
William FloresSep 6, 2025
What to do if water remains in my Atag DW7114SXB after a cycle?
- M
  Matthew YoderSep 7, 2025
  If water is remaining in your Atag dishwasher, here are some potential causes and solutions: * The filters may be blocked. Clean both the coarse and fine filters. * The filters might not be fitted correctly. Ensure the filter handle is locked in the stop position. * There could be debris in the drainage pump. Clean the drainage pump. * The drainage pump stop may be missing. Check that the colored stop on the right in the bottom drain is in place. * There might be a kink in the drainage hose. Make sure the hose is free from kinks and sharp bends. * The drainage hose could be blocked. Disconnect the drainage hose from the sink unit's water trap and check for any debris, ensuring the connection has an inner diameter of at least 14 mm.
E
emarshallSep 4, 2025
Why is my Atag Dishwasher making a rattling sound when dishwashing?
- M
  Mary MerrittSep 4, 2025
  A rattling sound when dishwashing in your Atag Dishwasher may be because the dishes are not correctly placed or the spray arms are not rotating. Check that the dishes are placed securely. Spin the spray arms to make sure they can rotate.
A
Allen SmithSep 3, 2025
Why is there detergent residue in the detergent compartment of my Atag DW7114SXB Dishwasher?
- V
  Virginia ReynoldsSep 3, 2025
  Detergent residue may remain in the detergent compartment after dishwashing because the detergent compartment was damp when adding detergent. The detergent compartment must be dry when adding detergent. Also, the detergent compartment may have been blocked. Check that the dishes are not preventing the detergent compartment from opening.
R
Ryan AndersonSep 2, 2025
How to remove the sticky white/blue film on dishes from Atag DW7114SXB?
- A
  Amy TannerSep 2, 2025
  The dishes may have a sticky white/blue film because the rinse aid dosage setting is too high. Reduce the dosage. If you have very soft water, you may want to dilute the rinse aid 50:50 with water.
T
Travis CruzSep 1, 2025
Why are there spots on stainless steel or silver in my Atag Dishwasher?
- E
  Eric BradySep 1, 2025
  Spots on stainless steel or silver in the Atag Dishwasher can be caused by some foodstuffs, such as mustard, mayonnaise, lemon, vinegar, salt and dressings, if left for too long. Rinse off these types of foodstuffs if not starting the dishwasher immediately. Use the Rinse and hold program. All stainless steel can cause spots on silver if they come into contact during dishwashing. Aluminium can also cause spots on dishes. In order to avoid marks and tarnishing, separate dishes made from different metals, such as silver, stainless steel and aluminium.
Z
Zachary SmithAug 31, 2025
How to remove grease deposits in Atag Dishwasher?
- M
  Matthew ArnoldAug 31, 2025
  Grease deposits in the Atag dishwasher may be due to low temperature programs having been selected for a prolonged period. Select a program with Intensive mode. The program will use a higher temperature to dissolve grease on very dirty dishes. Or run a self-cleaning program once or twice a month.
S
Shannon EllisAug 29, 2025
How to get rid of bad odour in Atag DW7114SXB Dishwasher?
- D
  deborah31Aug 30, 2025
  A bad odour in the Atag dishwasher may be due to dirt around the seals and in corners. Clean with washing-up brush and low foaming cleaner. Also, low temperature programs may have been selected for a prolonged period. Run a program with a high temperature once or twice a month. Or run a self-cleaning program.
M
Mark Brown Jr.Aug 28, 2025
What to do if water remains in the Atag DW7114SXB after cycle?
- W
  wagnerronnieAug 29, 2025
  If water remains in the Atag dishwasher, the filters may be blocked. Clean the coarse and fine filters. The filters may also not be fitted correctly. Check that the filter handle is locked in the stop position. Debris in the drainage pump, a missing drainage pump stop, a kink in the drainage hose, or a blocked drainage hose can also cause this issue. Clean the drainage pump, check that the coloured stop on the right in the bottom drain is in place, check that the hose is free from kinks and sharp bends, and disconnect the drainage hose where it connects to the sink unit's water trap to check for blockages.

Atag DW7114SXB Specifications

General

Type	Freestanding
Place settings	14
Water consumption per cycle	9.5 L
Width	60 cm
Delay Start	Yes
Half Load Option	Yes
Child Lock	Yes
Dimensions (H x W x D)	85 cm x 60 cm x 60 cm