Installation & Servicing Instructions ATAG Q-Series
37
13.5 User's instructions
Hand these instructions and the user manual to the user for retention and instruct in
the safe operation of the boiler and cylinder. Advise the user of the operation of the
cylinder temperature, and that normally a setting of max. which gives a stored water
temperature of approximately 60°C is adequate.
In hard water areas the DHW temperature setting should not exceed this
setting to avoid possible scale build-up.
Frost protection
Advise the user of the precautions necessary to prevent damage to the system and
to the building if the system does not remain operative during frost conditions.
Please ensure that if you are absent during a period of frost the central heating system
remains in operation and the rooms and CBS cylinder are kept above freezing point.
Finally, advise the user that for continued efcient and safe operation, the boiler and
cylinder should be serviced at least once a year by qualied servicing company. It is
important and strongly recommended that arrangements are made for a maintenance
agreement with a qualied servicing company to ensure regular servicing of the boiler
and cylinder.
Please contact ATAG Heating UK Ltd. for further details. Contact details can be found
on the back page of this manual.
13.6 Maintenance frequency
ATAG Heating UK Ltd advises an annual inspection, with a full strip down service
every 4 years, depending on the operational hours listed in the warranty conditions.
13.7 Warranty
For the warranty conditions we refer to the Warranty Card that is supplied with the
boiler.
To Next Page
Loading...
Need help?
General
