Atag Q 25S User Manual

Installation & Servicing Instructions ATAG Q-Series
4
1 Introduction
These instructions describe the functioning, installation, use and primary maintenance
of ATAG central heating units for the United Kingdom and Ireland. Where necessary
the different regulations for each country are separately described.
These instructions are intended for the use by Gas Safe Register approved contractors
or registered Bord Gais installers in connection with the installation and putting into
operation of ATAG boilers. It is advisable to read these instructions thoroughly, well in ad-
vance of installation. Separate instructions for use are supplied with the boiler for users
of ATAG central heating boilers. ATAG is not liable for the consequences of mistakes
or shortcomings which have found their way into the installation instructions or user’s
manual. Further, ATAG reserves the right to alter its products without prior notication.
When delivering the unit, give the customer clear instructions concerning its
use; present the customer with the user’s manual and card.
Each unit is tted with an identication plate. Consult the details on this plate to verify
whether the unit is compliant with its intended location, e.g.: gas type, power source
and exhaust classication.
On completion of the installation the installer or commissioning engineer must ll
out and complete the Benchmark Commissioning Checklist found on page 45 of this
manual and hand this to the customer for future record keeping. The Benchmark
Service Record must also be completed by the service agent following each service
call, and return to the customer. A copy of the Benchmark Commissioning Checklist
must be returned to ATAG Heating along with the warranty registration card to register
the appliance for the standard warranty benets.
Relevant Installation, Service and User manuals:
- ATAG Cascade Hydraulic cascade system
- ATAG Monopass Flue system individual
- ATAG PP Overpressure Flue system cascade
- ATAG BrainQ Digital room thermostat
- ATAG MadQ Cascade-/Zone controller
2 Rules
The following regulations apply to installation of ATAG central heating units:
Legislation and Regulations.
Gas Safety (Installation and Use). All gas appliances must by law, be installed by a com-
petent person, eg. Members of Gas Safe Register and in accordance with the current
Gas Safety Regulation. Failure to install appliance correctly could lead to prosecution.
All Gas Safe Register approved contractors carry a Gas Safe Register ID Card and
have a registration number. You can call Gas Safe Register direct on 01256 372300
In addition to the above regulations this appliance must be installed in compliance
with the current IEE Regulations, the Building Standards (Scotland Consolidation)
Regulations. Regulations and bye laws of the Local Water Authority and the Current
Health and Safety Regulation.
The Benchmark Scheme
Benchmark places responsibilities on both manufacturers and installers. The purpose
is to ensure that customers are provided with the correct equipment for their needs,
that it is installed, commissioned and serviced in accordance with the manufacturer’s
instructions by competent persons and that it meets the requirements of the appro-
priate Building Regulations. The Benchmark Checklist can be used to demonstrate
compliance with Building Regulations and should be provided to the customer for
future reference.

Atag Q 25S Specifications

General

Brand	Atag
Model	Q 25S
Category	Boiler
Language	English