AT&T 7406 Plus - Select Button

Select Button
✔
To use any of the
1
Choose any of the following after pressing  -Select :
features that require
the Select button
●
( -Select )
●
●
●
Press  Drop-Test  to initiate a self-test of your voice
terminal lights, ringer, and display, if you have one.
For procedures, see “Self-Test” in this section.
Press  Conference-Ring  to select one of 8 personalized ringing
patterns for your voice terminal. For procedures,
refer to “Select Ring” in this section.
Press  Speaker-Reset Spkr  to adjust the sound level and
quality of your built-in speakerphone. Use whenever
you move your voice terminal to a different location
(even in the same room), when the terminal is
unplugged, or when there has been a power failure.
For procedures, refer to “Speakerphone” in this
section.
Press a 2-level feature button to access the top-labeled
feature. Use the procedure below.
To use the Select
1
Press  -Select  to access any of the top labeled features
button to access the
on buttons with split labels
top-labeled feature on
2-level buttons
●
Green light goes on
2
Press the split-labeled button whose top feature you
wish to use
Note: When you press the chosen feature button, the
green light for  -Select  automatically goes off; begin
again at Step 1 to use another top-labeled feature.
24