To cancel Send All
1
Press
Send All Calls
or
SAC Group
again (while on-hook or off-
Calls or SAC Group
hook)
or lift handset and dial Send All Calls cancel code
[confirmation tone]
●
Your calls ring at your own voice terminal again
Speaker
Note:
Your voice terminal is set for either the Speaker (listen-only)
or
the
Speakerphone (listen and talk) function. Check with your System Manager to see
which of these two features you can use. You can use Reset Spkr feature to adjust the
sound level and quality of your speakerphone
only if
your voice terminal is set for
Speakerphone (listen and talk).
Use the following procedures if your voice terminal is set for the Speaker (listen only)
feature.
To place a call without
lifting the handset, or
to use speaker with
any listening-only
feature activity (such as
monitoring a call on
which you have been
put on hold or for
retrieving messages)
1
Press
Speaker-Reset Spkr
●
Green light next to
Speaker-Reset Spr
goes on; red light
next to
Mute
goes on
2
Place call or access selected feature
3
Adjust speaker volume if necessary
●
To raise the volume, press the right half of the
Volume control button, labeled
[
▲
];
to lower the
volume, press the left half of the Volume control
button, labeled [ ▼ ]
27
To Next Page
Loading...
