AT&T 7406 Plus - Inspect; Message Retrieval

Inspect
To see who’s calling
1
Press  Inspect 
while on a call
●
Name and number of caller are shown if from
extension; [ OUTSIDE CALL
] or other trunk source is
shown if from outside
2
Press  Normal  to return to display for present call
To see who’s on hold
while on a call
1
Press  Inspect 
2
Press  xxxxx  of held call
●
You remain connected to present call
To answer a new call
1
Press  Normal  (if not already in normal mode)
while on a call
●
Finish present call or put on hold
2
Press  xxxxx  of new call
Message Retrieval
✔
To see your messages
1
Press  Message Retrieve 
when your message
2
light is on (while on-
Press  Next Message  to see first message (and then for each
following message)
hook, off-hook, or on a
call)
To return a call to a
1
Pick up handset or activate speakerphone
[dial tone]
message sender
2
Press  Return Call  while any part of message is shown
To erase a message
1
Press  Delete  while any part of message is shown
To see a principal’s
1
Select an idle  xxxxx  button, or put principal on hold
(co-worker’s) messages
and select an idle  xxxxx  button
[dial tone]
(can be during a call
with principal)
2
Press  Covr Msg Retrieve 
3
Dial principal’s extension
33