AT&T 7406 Plus - Select Ring and Ringer Volume

Select Ring and Ringer Volume
✔
To select a personalized
1
Press  -Select  (while on-hook)
ring
●
Green light goes on
2
Press  Conference-Ring 
●
●
●
Green light next to  -Select  flutters
Current ring pattern plays and repeats every 4
seconds
If you have a display, it shows
[ PERSONAL RING #x ] (x will be a number from 1
to 8)
3
Continue to press  Conference-Ring  to cycle through all 8
ringing patterns
4
When you hear the desired ringing pattern, press
 -Select  again
●
Your new ring is set. Light next to  -Select  goes off
Note: If you receive a call, go off-hook, or lose power
during selection, process is interrupted and you must
begin again. If you lose power after selection, you will
also have to select your ring pattern again.
To adjust ringer
1
To raise the volume, press the right half of the Volume
volume if necessary
control button labeled [ ▲ ]. To lower the volume, press
the left half of the Volume control button labeled [ ▼ ].
●
If you have a display, it shows [ RINGER L>>>> H ]
(There are 8 possible volume settings. On the
display, 1 arrow is the lowest setting, and 8 arrows is
the highest setting)
25