EasyManuals Logo

AT&T CL81114 User Manual

AT&T CL81114
109 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
8
Battery installation and charging
Install the battery as shown on page 9. Once you have installed
the battery, the screen indicates the battery status (see the
following table). If necessary, place the handset in the telephone
base or charger to charge the battery. For best performance, keep
the handset in the telephone base or charger when not in use. The
battery is fully charged after ten hours of continuous charging. See
the table on page 99 for battery operating times.
If the screen shows Place in charger and
flashes, you need to
charge the handset without interruption for at least 30 minutes to
give the handset enough charge to use the telephone for a short
time. The following table summarizes the battery charge indicators
and actions to take.
Getting started
Battery indicators Battery status Action
The screen is blank, or
shows Place in charger
and (flashing).
Battery has no or
very little charge. The
handset cannot be used.
Charge without interruption
(at least 30 minutes).
The screen shows
Low battery and
(flashing).
Battery has enough
charge to be used for a
short time.
Charge without interruption
(at least 30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery
charged, place it in the
telephone base or charger
when not in use.
NOTE: If you are on a phone call in low battery mode, you hear four short
beeps every minute.

Table of Contents

Other manuals for AT&T CL81114

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AT&T CL81114 and is the answer not in the manual?

AT&T CL81114 Specifications

General IconGeneral
BrandAT&T
ModelCL81114
CategoryCordless Telephone
LanguageEnglish

Related product manuals