Multiple handset use
41
Push-to-talk (PTT)
Make an outgoing call during PTT call
During a one-to-one PTT call, press PHONE/FLASH to get a dial
tone. The PTT call ends automatically.
During a one-to-group PTT call, press
PHONE/FLASH on the
initiating handset. The PTT call ends automatically and you get a
dial tone.
During a one-to-group PTT call, press PHONE/FLASH on any
one of the destination handsets. That handset gets a dial tone.
The PTT call continues for the rest of the PTT participants.
End or leave a PTT call
For one-to-one PTT calls, both initiating and destination handsets
can end the PTT call. For PTT calls to multiple handsets, the
initiating handset can end the PTT call. If any one of the
destination handsets leaves the PTT call, the call continues until all
participants or the initiator hangs up.
Press
OFF/CANCEL on the handset. The screen shows Push to
talk Ended.
-OR-
Place the handset in the telephone base or charger, then the
handset return to idle mode.
NOTE: After PUSH TO TALK is released, the PTT call remains open for a short
time. If no one presses PUSH TO TALK within ten seconds, the PTT call ends
automatically.
•
•
•
To Next Page
Loading...
Need help?
General
