Multiple handset use
37
Push-to-talk (PTT)
PTT call to a single handset
1. There are a few ways to begin a PTT call to a
single handset. When the handset is not in use:
If you have 2 handsets and no other
registered devices, press and hold
PUSH TO TALK.
If you have more than two handsets and/or
cordless headset(s)/speakerphone(s):
Press PUSH TO TALK on the handset, then
use the dialing keys to enter the destination
handset number.
-OR-
Press PUSH TO TALK on the handset. PressPress
q
CID or pDIR to highlight the destination
handset number, then press MENU/SELECT
or PUSH TO TALK.
The handset shows Connecting to HANDSET X...
(HANDSET
represents the handset name, X represents the destination
handset number).
When the connection is made, both your and
the destination handset screens display
Press and hold [PTT] to talk.
2. Press and hold PUSH TO TALK. A chirp
indicates your microphone is on. Speak towards
the handset. Your voice is broadcast to the
destination handset.
While you are speaking, your handset shows
PTT To handset: X.
3. Release PUSH TO TALK after speaking. Both handsets beep
once again and the screens show Press and hold [PTT] to
talk, then you can press and hold PUSH TO TALK to continue
speaking or the destination handset can respond (see Answer a
PTT call on page 39).
4. To end the PTT call, press
OFF/CANCEL or place the handset in
the telephone base or charger. The handset shows Push to
talk ended.
•
•
PTT To
handset: X
PUSH TO TALK
>Handset X
Connecting to
Handset X...
Press and hold
[PTT] to talk
To Next Page
Loading...
