Answering system
43
Answering system settings
Call screening
Use this feature to choose whether incoming messages can be
heard over the telephone base when they are being recorded. If
you turn call screening on, you hear the incoming message.
To change the setting:
1. When the handset is in idle mode, press MENU/SELECT to enter the
main menu.
2. Press qCID or pDIR to scroll to Answering sys, then press
MENU/SELECT.
3. Press qCID or pDIR to scroll to Ans sys setup, then press
MENU/SELECT.
4. Press MENU/SELECT to select Call screening.
5. Press qCID or pDIR to choose On or Off.
6. Press MENU/SELECT to save the setting.
Number of rings
You can set the answering system to answer an incoming call
after two, three, four, five or six rings. You can also select toll
saver. If toll saver is selected, the answering system answers a
call after two rings when you have new messages, and after four
rings when there are no new messages. This feature allows you to
check for new messages and avoid paying long distance charges
when calling from out of your local area. By default, the answering
system answers an incoming call after four rings.
To set the number of rings:
1. When the handset is in idle mode, press MENU/SELECT to enter the
main menu.
2. Press qCID or pDIR to scroll to Answering sys, then press
MENU/SELECT.
3. Press qCID or pDIR to scroll to Ans sys setup, then press
MENU/SELECT.
4. Press qCID or pDIR to scroll to # of rings, then press
MENU/SELECT.
5. Press qCID or pDIR to choose among 2, 3, 4, 5, 6 or Toll saver.
6. Press MENU/SELECT to save the setting.
To Next Page
Loading...
Need help?
General
