AT&T CL82309 - AT&T DECT 6.0 User Manual

Getting started
5
Telephone base & charger installation
Install the telephone as shown below.
The telephone base is ready for tabletop use. If you want to change to wall
mounting, see page 8 for details.
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this product. To order a replacement power
adapter, visit our website at
www.telephones.att.com, or call
1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.
2. The power adapters are intended to be correctly oriented in a vertical or floor mount position.
The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-
the-table or cabinet outlet.
1. Plug one end of
the telephone line
cord into the
telephone jack on
the bottom of the
telephone base.
2. Route the power adapter cord through the slot.
3. Plug the small
end of the
telephone base
power adapter
into the power
jack on the
bottom of the
telephone base.
4. Place the cords
into the
channels.
5. Plug the large end of
the power adapter
into a power outlet
not controlled by a
wall switch.
Power
adapter
If you have DSL high
speed Internet
service, a DSL filter
(not included) is
required.
Telephone line
cord
6. Plug the other end
of the telephone
line cord into a
telephone jack or a
DSL filter.
7. Raise the antenna.
Plug the power adapter
into an electrical outlet
not controlled by a wall
switch.
Charger
installation
Plug the small end of
the charger adapter
into the power jack on
the bottom of the
charger.

AT&T CL82309 - AT&T DECT 6.0 Specifications

General

Brand	AT&T
Model	CL82309 - AT&T DECT 6.0
Category	Cordless Telephone
Language	English