AT&T CL82309 - AT&T DECT 6.0 User Manual

Handset settings
19
Answering system settings
Message alert tone
When the message alert tone is set to ON, and there is at least one new
message, the telephone base beeps every 10 seconds. Unless you change it,
the message alert tone is set to off.
There is no audible alert at the handset.
To change the setting:
1. When the handset is in idle mode, press MENU/
SELECT
to enter the main menu.
2. Press
MENU/SELECT again.
3. Press TCID or DIRS to scroll to >ANS SYS SETUP,
then press
MENU/SELECT.
4. Press TCID or DIRS to scroll to >MSG ALERT TONE,
then press
MENU/SELECT.
5. Press TCID or DIRS to choose between ON and OFF.
6. Press
MENU/SELECT to confirm your setting and you
hear a confirmation tone.
NOTES:
1. The message alert tone beeps only if all the conditions below
are met:
- Answering system is on.
- Message alert tone setting is on.
- There are new messages.
2. To temporarily turn off the message alert tone, see page 40.
QMBZ!NTHT
?BOT!TZT!TFUVQ
BOT!PO0PGG
?NTH!BMFSU!UPOF
PO
NTH!BMFSU!UPOF
EJSFDUPSZ
?BOT/!TZTUFN

AT&T CL82309 - AT&T DECT 6.0 Specifications

General

Brand	AT&T
Model	CL82309 - AT&T DECT 6.0
Category	Cordless Telephone
Language	English