Handset settings
17
Answering system settings
To delete your outgoing announcement:
1. When the handset is in idle mode, press MENU/
SELECT to enter the main
menu.
2. Press
MENU/SELECT again.
3. Press TCID or DIRS to scroll to >ANS SYS SETUP, then press
MENU/SELECT.
4. Press TCID or DIRS to scroll to >ANNOUNCEMENT, then press
MENU/SELECT, the system announces, "To play, press 2. To record,
press 7."
5. Press 3 to delete your recorded announcement.
When your announcement is deleted, the system answers calls with the pre-
recorded announcement described on the previous page.
Number of rings
You can set the answering system to answer an incoming call after two, four,
or six rings. You can also select toll saver, which is explained below. Unless
you change it, the answering system answers an incoming call after four
rings.
To set the number of rings:
1. When the handset is in idle mode, press MENU/
SELECT
to enter the main menu.
2. Press
MENU/SELECT again.
3. Press TCID or DIRS to scroll to >ANS SYS SETUP,
then press
MENU/SELECT.
4. Press TCID or DIRS to scroll to ># OF RINGS, then
press
MENU/SELECT.
5. Press TCID or DIRS to scroll and choose among 2, 4, 6
or TOLL SAVER.
• Toll saver - the answering system answers a call
after two rings if you have new messages, and
after four rings when there are no new messages.
This feature allows you to check for new messages
and avoid paying long distance charges when
calling from out of your local area.
6. Press
MENU/SELECT to confirm your setting and you
hear a confirmation tone.
NOTE: If you subscribe to caller ID/call waiting service through your telephone service
provider, see Answering system and voicemail on page 39.
QMBZ!NTHT
?BOT!TZT!TFUVQ
SFNPUF!DPEF
?$!PG!SJOHT
3
$!PG!SJOHT
EJSFDUPSZ
?BOT/!TZTUFN
To Next Page
Loading...
