Handset settings
12
Telephone settings
The answering system announces the day and time of the message prior to
playing it. Before using the answering system, set the date and time as
follows. If you subscribe to caller ID service, the day and month are set
automatically with each incoming call. The year must be set so that the day
of the week can be calculated from the caller ID information.
Set date/time
Follow the steps below to set the month, day, year and time.
1. When the handset is in idle mode, press MENU/
SELECT to enter the main
menu.
2. Press TCID or DIRS to scroll to >SET DATE/TIME,
then press
MENU/SELECT.
3. Press TCID or DIRS to select the month, or enter the
correct number using the dial pad, then press
MENU/SELECT to confirm.
4. Press TCID or DIRS to select the day, or enter the
correct number using the dial pad, then press
MENU/SELECT to confirm.
5. Press TCID or DIRS to select the year, or enter the
correct number using the dial pad, then press
MENU/SELECT to confirm.
6. Press TCID or DIRS to select the hour, or enter the
correct number using the dial pad, then press
MENU/SELECT to confirm.
7. Press TCID or DIRS to select the minute, or enter the
correct number using the dial pad, then press
MENU/SELECT to confirm.
8. Press TCID or DIRS to select the AM or PM, then
press
MENU/SELECT to confirm. There is a confirmation tone.
NOTE: If the clock is not set when a message is recorded, the system announces, "Time
and day not set." before it plays the message.
EJSFDUPSZ
?BOT/!TZTUFN
DMS!WPJDFNBJM
?TFU!EBUF0UJNF
..0..0..
TFU!EBUF
..;..0..
TFU!UJNF
To Next Page
Loading...
Need help?
General
